How-to guide
Setting Up Your Chronograph: Placement, Settings and Missed Shots
You set the chronograph up, fire a careful first shot, and the screen stays blank. Before you suspect a fault, check how it's pointed and where it's sitting; those are the first things Garmin's own troubleshooting steps cover. This guide covers the setup that avoids it, from the kitchen table to the bench, and what to check when a shot doesn't register.
It's written around the three radar chronographs we stock, the Garmin Xero C2 and C1 Pro and the Athlon Velocity Pro. If you haven't chosen one yet, start with our radar chronograph comparison.
At home, before the first trip
The range bench is a bad place to discover a flat battery or a pending software update. Do the dull jobs on the kitchen table the night before, using the checklist below.
Pairing catches people out. Garmin's manual says to pair through the ShotView app, not your phone's Bluetooth settings, with the chronograph and phone within 3 m of each other; you'll also need a Garmin account. The Athlon pairs under Settings, then Connection, and you connect from the Athlon Ballistics Lite app. Both apps can push firmware updates, and Garmin units can also update through Garmin Express on a computer.
Turn on projectile weight entry if you want kinetic energy and power factor. On the Garmins it's a setting; on the Athlon, choose New Session rather than Quick Start.
Placing it at the bench
This is the part that decides whether you get readings. Garmin's manuals give exact distances for a rifle session, shown in the diagram below.
Put the chronograph 15 to 35 cm to the side of the rifle and 15 to 35 cm behind the muzzle, either side of the rifle. Its large, flat side points at the target and the screen faces you. Garmin also wants at least 20 m of clear flight path in front of the unit. Athlon's manual is simpler: within 4 to 10 inches, about 10 to 25 cm, of the muzzle.
Two practical tweaks of our own. With a semi-auto, set the chronograph on the side away from the ejection port; Garmin warns against placing it where ejected cases or muzzle blast can hit it. And with a big muzzle brake, use the back end of the distance range so the blast isn't hammering the unit.
Pistols and bows work differently. You hold the firearm or bow above the chronograph so the barrel or arrow passes 15 to 35 cm over it. For archery, Garmin asks for a target at least 4 m away.
When it misses a shot
If a shot doesn't register, work down the list below before assuming the unit is faulty. It follows Garmin's own troubleshooting order.
The velocity range is easy to overlook. Each session type expects its own range, and Garmin lists the wrong choice as a cause of missed readings. If you're shooting fast strings, remember the C1 Pro has no published rapid-fire rate, while the Xero C2 is rated for up to 10 rifle shots a second.
Readings from the next bay are a different problem. Garmin suggests keeping the nearest shooter at least 1.5 m away. The Athlon claims to tell your bullet from a neighbour's, which we cover in our Athlon Velocity Pro review. Either way, a stray reading can be deleted on the unit or excluded in the app.
Heat, cold and charging
Australian summers test electronics. The Garmins operate from -10 to 55°C, and Garmin's manual says the unit shuts down to protect itself if it overheats; if you see a temperature warning, move it into shade. A chronograph sitting on a steel bench in January sun heats up quickly, so a towel or a bit of shade cloth over the unit between strings is worth packing.
Charging has its own window: 0 to 45°C on the Garmins. A unit left on the dashboard or in a frosty ute may refuse to charge until it settles to a moderate temperature. Dry the USB port and its weather cap before you plug in.
Once you're getting clean readings, the next step is reading them properly. Our guide to SD and ES explains how many shots you need before you trust the numbers.
Chronograph Setup FAQ
How far from the muzzle should a radar chronograph be?
For a rifle, Garmin's manuals say to place the Xero C1 Pro or C2 15 to 35 cm behind the muzzle and 15 to 35 cm to the side of the rifle. Athlon's manual says to place the Velocity Pro within 4 to 10 inches, about 10 to 25 cm, of the muzzle. Keep it out of the path of muzzle blast and ejected cases.
Which side of the rifle should the chronograph go on?
Garmin's manual says the Xero chronograph can go on either side of the rifle. With a semi-automatic, we'd place it on the side away from the ejection port so spent cases don't hit it, since Garmin warns against positioning it where ejected cartridge cases or muzzle blast could damage the unit.
Why is my chronograph not picking up shots?
Usually it's orientation or spacing. Check that a session is running, the large flat side faces the target with the screen facing you, the unit is 15 to 35 cm beside and behind the muzzle, you chose the right velocity range, and there's at least 20 m of clear flight path. Also check you're not shooting faster than the unit's rated shot rate.
Can I use a radar chronograph at an indoor range?
Yes, provided the range is long enough. Garmin says its Xero chronographs work indoors and outdoors, but the projectile needs to travel at least 20 m in front of the unit for a reliable reading. For archery, Garmin asks for a target at least 4 m away. Shorter indoor lanes may not give consistent results.
How do I pair a Garmin Xero chronograph with my phone?
Pair through the ShotView app, not your phone's Bluetooth settings. On the chronograph, go to Settings, then Connectivity, enable Bluetooth and select Pair Phone. Keep the phone within 3 m, scan the QR code to install ShotView, then sign in to a Garmin account and follow the on-screen steps to finish pairing.
Why did my chronograph turn off on a hot day?
Garmin's Xero chronographs shut down to prevent overheating when used above their 55°C operating limit, and display a temperature warning first. A unit sitting in direct summer sun on a metal bench can get hotter than the air around it. Move it into shade, let it cool, and cover it between strings.
How do I set up a radar chronograph for a pistol?
Start a pistol session, then hold the pistol over the chronograph so the barrel is 15 to 35 cm above it, according to Garmin's manual. Keep the large flat side facing the target. The Xero C2 is rated for up to 3 shots a second in a pistol session, so very fast strings may not record every shot.
Do I need to enter projectile weight?
Only if you want kinetic energy and power factor. Velocity, average, standard deviation and extreme spread work without it. On Garmin Xero units, turn on projectile weight entry in the settings and you'll be prompted each session. On the Athlon Velocity Pro, choose New Session rather than Quick Start to enter the weight.
Can a chronograph read shots from the shooter next to me?
Yes, it can happen. Garmin recommends keeping the nearest shooter at least 1.5 m away. The Athlon Velocity Pro's specification sheet says it identifies the correct bullet when several shooters are present. If a stray reading slips in, delete it on the unit or exclude it from your statistics in the app.
How do I update my chronograph's firmware?
Garmin Xero units update through the ShotView app, which sends updates automatically and prompts you to install them, or through Garmin Express on a computer via USB-C. Athlon says the Velocity Pro's firmware updates over Bluetooth. Do updates at home, keep the unit charged, and don't switch it off mid-install.
Placement distances and troubleshooting steps come from Garmin's Xero C1 and C2 owner's manuals and Athlon's Velocity Pro user manual.