The Hawke Match Mount 1" 2 Piece 9–11mm High (Model 22102) is a two-piece riflescope ring set designed to secure 1-inch (25.4 mm) optics to standard dovetail rails. Machined from high-grade anodised aluminium alloy with rounded edges in a matte black finish, this mounting system positions the optical centre approximately 1.5 inches (38 mm) above the rail. It provides the clearance necessary for large objective bells on rimfire rifles and airgun platforms while preventing scope movement under recoil.

Key Features

• Internal Cushion Tape: Protective internal ring lining prevents direct metal-on-metal contact, dampening vibrations and protecting the scope tube from marring.
• Retractable Recoil Stop Pin: Anchors directly into receiver recesses to resist bidirectional spring-piston airgun recoil and eliminate scope creep.
• Reversible Dovetail Clamp: Clamping plate accommodates both 9–11 mm metric dovetails and 3/8" rifle receivers.
• Double Hex Cap Screws: Utilises four hex screws per ring (two per side) to maintain firm, uniform clamping pressure around the scope tube.

Specifications

• Scope Tube Diameter: 1 inch (25.4 mm)
• Mount Height Profile: High (positions optical centre ~1.5 inches / ~38 mm above rail)
• Rail Compatibility: 9–11 mm Dovetail and 3/8" bases
• Fasteners: Double hex screws per ring cap; single hex clamp screw per base
• Configuration: 2-piece set
• Material: Anodised aluminium alloy
• Finish: Matte Black

Who is the Hawke Match Mount 1" 2 Piece High for?

• Pest control airgun shooters — Requires a high mount profile positioning the optical centre approximately 38 mm (1.5 inches) above the receiver to clear large 50 mm to 56 mm objective bells on spring-piston, CO2, or PCP air rifles, while utilising a built-in recoil stop pin to arrest bidirectional spring recoil.
• Rimfire hunters — Mounts 1-inch (25.4 mm) tube optics onto factory 9–11 mm or 3/8-inch receiver grooves on .22 LR or .17 HMR rifles, providing adequate clearance between the barrel and larger objective lenses without needing aftermarket conversion rails.

Less suitable for: Firearm receivers equipped with Picatinny (MIL-STD-1913) or Weaver rails (which require Weaver/Picatinny pattern rings), optics with 30 mm or 34 mm maintubes, or scopes with 30 mm to 38 mm objectives (which achieve a better cheek weld using Low profile mounts) and 40 mm to 48 mm objectives (which require Medium profile mounts).